TM 5-3895-379-10
OPERATION UNDER USUAL CONDITIONS
GENERAL
1.
This work package contains instructions for safely operating the CB534B and CB534C Rollers, Motorized, Vibrating
Tandem Steel Drums under usual conditions. Unusual conditions are defined and described in WP 0006 00.
2.
Refer to WP 0004 00 for the location and function of all controls and indicators required for roller operation.
3.
CB534B Roller is shown unless otherwise indicated.
INITIAL ADJUSTMENTS AND DAILY CHECKS
WARNING
Operators must wear protective head gear. Failure of operators to wear protective head gear may result
in serious injury or death.
Unlock steering frame before operation to prevent loss of steering that may cause injury or death.
1.
Unlock Steering Frame.
a.
Remove clip (1) and pin (2) from articulation
yoke (3).
b.
Lift and hold steering frame lock bolt (4) to top
of slot in articulation yoke (3).
c.
Install pin (2) in top hole in articulation yoke (3),
ensuring steering frame lock bolt (4) is above pin
(2).
d.
Release steering frame lock bolt (4) and install
clip (1) in pin (2).
2.
Lock Steering Frame.
a.
Remove clip (1) and pin (2) from articulation
yoke (3).
UNLOCKED
b.
Position steering frame lock bolt (4) to bottom of
POSITION
slot in articulation yoke (3).
1
c.
Install pin (2) in bottom hole in articulation yoke
4
(3), ensuring steering frame lock bolt (4) is
below pin (2).
LOCKED
2
d.
Install clip (1) in pin (2).
POSITION
3
401-2166
3.
Adjust Handrails for Operation. When rolling operations require operator to watch surfaces or edges of both drums,
such as side-to-side rolling, operator station can be moved 90 degrees in either direction. Handrails can be moved out to
make room for the seat to travel fully back while in 90-degree rotation. Size and space requirements of the operator will
determine if adjustment of handrails is needed. Refer to WP 0022 00 when handrail adjustment is required.