TM 5-3895-346-14
ENGINE OVERHAUL
CONNECTING ROD
Figure 3. Magnetic Particle Inspection Limits for Connecting Rod
2.
Insert spray nozzle remover J 8995
through the upper end of the
connecting rod and insert the pin (in the
curved side of the tool) in the opening
in the bottom of the spray nozzle.
3.
Support the connecting rod and tool in
an arbor press as shown in Fig. 5.
4.
Place a short sleeve directly over the
spray nozzle. Then press the nozzle
out of the connecting rod.
5.
Remove the tool.
6.
Start the new spray nozzle, with the
holes positioned as shown in Fig. 6,
straight into the counterbore in the
connecting rod.
Figure 4. Removing or Installing
Bushings
149