TM 5-3895-383-24
WARNING
· Drycleaning Solvent (P-D-680, Type lII) is TOXIC and flammable. We protective goggles
and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and clothes;
and, do not breathe vapors. Keep away from heat or flame. Never smoke when using
solvent; the flashpoint for drycleaning solvent type III is 200°F (93°C). Failure to do so
may result in injury or death to personnel.
· If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent
contacts eyes, immediately flush eyes with water and get immediate medical attention.
g.
Keep It Clean. Dirt, grease, oil, and debris only get in the way and may cover up a serious problem. Clean as you work and
as needed. Use drycleaning solvent (P-D-680, Type III) on all metal surfaces. Use soap and water when you clean rubber or plastic
material.
(1)
Rust and Corrosion. Check Roller body and frame for rust and corrosion. If any bare metal or corrosion exists, clean and
apply a thin coat of oil. Report it to your supervisor.
(2)
Bolts, Nuts, and Screws. Check all attaching hardware for obvious looseness, missing, bent, or broken condition. You
can't try them all with a tool, but look for chipped paint, bare metal, or rust around bolt heads. If you find a bolt, nut, or screw you think
is loose, tighten it or report it to your supervisor.
(3)
Welds. Look for loose or chipped paint, rust, or gaps where parts a welded together. If you find a bad weld, report it to
your supervisor.
(4)
Electric Wires and Connectors. Look for cracked, frayed, or broken insulation, bare wires, and loose or broken
connectors. Tighten loose connectors. Report any damaged wires to your supervisor.
(5)
Hoses and Fluid Lines. Look for chafing, wear, damage, and leaks, and make sure clamps and fittings are tight. Wet
spots show leaks, but a stain around a fitting or connector can also mean a leak. If a leak comes from a loose fitting or connector,
tighten it. If something is broken or worn out, report it to your supervisor.
h.
When you check for "operating condition", look at the component to see if it's serviceable.
1-5
