TM 5-3895-383-10
Safety Section
4-12
Mounting and Dismounting
Mounting and Dismounting
SMCS Code: 7000
Illustration 7
Mount the machine and dismount the machine only at
locations that have steps and/or handholds. Before you
mount the machine, clean the steps and the
handholds. Inspect the stairs and handholds. Make any
necessary repairs.
Face the machine whenever you mount the machine
and whenever you dismount the machine.
Maintain a three-point contact with the steps and with
handholds.
NOTE: Three-point contact can be two feet and one
hand. Three-point contact can also be one foot
and two hands.
Never mount a moving machine. Never dismount a
moving machine. Never jump off the machine.
Do not carry tools or supplies when you try to mount
the machine or when you try to dismount the machine.
Use a hand line to pull equipment onto the platform.
Do not use any controls as handholds when you enter
the operator compartment or when you exit the
operator compartment.
Before Starting Engine
SMCS Code: 1000; 7000
Make sure that the steering frame lock link is stored in
the unlocked position. The steering frame lock link
must be removed in order to steer the machine. Start
the engine only from the operator compartment. Never
short across the starter terminals or across the
batteries. Shorting could damage the electrical system
by bypassing the engine neutral start system.
Inspect the condition of the seat belt and of the
mounting hardware. Replace any parts that are worn or
damaged. Regardless of appearance, replace the seat
belt after three years of use. Do not use a seat belt
extension on a retractable seat belt.
Make sure that the machine is equipped with a lighting
system that is adequate for the job conditions. Make
sure that all machine lights are working properly.
Before you start the engine and before you move the
machine, make sure that no one is underneath the
machine, around the machine, or on the machine.
Make sure that that area is free of personnel.
Engine Starting
SMCS Code: 1000; 7000
Illustration 8
Do not start the engine or move any controls if there is
a "Do Not Operate" or similar warning tag attached to
the start switch or controls.
Move the parking brake switch to the "ON" position.
Start the engine and operate the engine in a well-
ventilated area. In an enclosed area, vent the exhaust
to the outside.
