TM 5-3895-382-24
Every 100 Service Hours or Monthly
You must read and understand the warnings and
instructions contained in the Safety Section of this
manual before performing any operation or maintenance
procedures.
Drum Gear Reducer
Check Level
1.
Move the machine until the plug is either at the
three o'clock or nine o'clock position. Remove the
plug.
NOTICE
Rotate the drum with the plug in the 12:00 o'clock
position down to the 3:00 or 9:00 o'clock position.
This will insure there is no oil trapped in the plug
cavity and give a false "FULL" reading.
2.
Maintain gear lubricant to the bottom of the plug.
3.
Clean and install the plug.
Axle Gear Reducer
Check Level
Located under the rear of the machine in front of the
differential.
1.
Remove fill/check plug located on front side of the
axle reducer case.
2.
Maintain gear lubricant to the bottom of fill/check
plug.
3.
Clean and install plug.
Maintenance Section
Every 100 Service Hours or Monthly
1-64
