TM 5-3895-379-23
DRUM ASSEMBLY REPLACEMENT - CONTINUED
0210 00
INSTALLATION - CONTINUED
1.
Remove chocks (TM 5-3895-379-10). Place drum assembly (24) into lifting device.
2.
Raise drum assembly (24) until it is just off floor. Move drum assembly into roller yoke or frame.
NOTE
The CB534B Roller model has shims between drum support (3) and yoke (8) on vibratory side of drum
assembly. Note the number of shims when replacing six bolts.
3.
On vibratory side of drum assembly (24), install six bolts (31) and washers (32) that fasten drum support (3) to yoke
(11). For the CB534B Roller, install shims (33).
4.
On propel side of drum assembly (24), install eight bolts (29) and washers (30) that fasten drum support (3) to yoke (11).
5.
Remove the lifting device from drum assembly (24). Remove jackstands from both sides of yoke (11).
6.
For the rear drum assembly (24), connect six hose assemblies (27) to propel motor (28).
27
28
61
24
401-2033
7.
For the front drum assembly (24), connect five hose assemblies (25) to propel motor (26).
25
26
24
401-2032
0210 00-8