TM 5-3895-379-23
GROUND CABLE REPLACEMENT - CONTINUED
0107 00
CLEANING AND INSPECTION
1.
Check cable ends for corrosion. Clean as necessary.
2.
Check for torn or frayed wires on ground strap (4) and ground cable (3).
3.
Check for continuity by attaching positive and negative lead of multimeter to opposite ends of cable. Reading of infinite
ohms means there is good continuity. Discard cable if reading shows less than infinite ohms.
4.
Check contact points of frame assembly (5) and flywheel housing (8) for corrosion. Clean as necessary.
5.
Replace all damaged parts.
INSTALLATION
1.
Install ground cable (3) on engine block (15) with screw (13) and washer (14). Tighten screw to 28-42 lb-ft (38-57
Nm).
2.
Install clamp (11) on ground cable (3).
3.
Install clamp (11) on bracket (12) with washer (10) and screw (9). Tighten screw to 60-90 lb-ft (81-122 Nm).
4.
Install ground strap (4) on flywheel housing (8) with washer (7) and screw (6). Tighten screw to 60-90 lb-ft (81-122
Nm).
5.
Install ground cable (3) and ground strap (4) on frame assembly (5) with washer (2) and screw (1). Tighten screw to 28-
42 lb-ft (38-57 Nm).
13
15
6
14
3
9
7
1
2
10
8
11
4
3
5
12
401-538
6.
Close right-side door assembly (TM 5-3895-379-10).
7.
Remove chocks (TM 5-3895-379-10).
END OF WORK PACKAGE
0107 00-2
