TM 5-3895-379-10
OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS) - CONTINUED
0012 00
Table 1. Operator Preventive Maintenance Checks and Services (PMCS) for DSWR - Continued.
LOCATION
ITEM TO
ITEM
MAN-
CHECK/
NOT FULLY MISSION
NO.
INTERVAL
HOURS
SERVICE
PROCEDURE
CAPABLE IF:
35
During
Steering
Check for any unusual steering noise, Steering binds or is unre-
binding or difficulty in turning.
sponsive.
CAUTION
36
During
0.2 Hours Hydraulic
Oil Level
Do not overfill hydraulic oil tank. Damage to hydraulic system
(Warm Oil
components may occur.
Check)
NOTE
The roller should be parked on level surface when checking the
hydraulic oil level.
Hydraulic oil is checked warm and cold. Run engine at least five
minutes before performing warm oil check.
Check that hydraulic oil level is Hydraulic oil level is below
between the high and low marks on the "LOW" level mark or above
label beside the hydraulic oil tank sight "HIGH" level mark on label.
gauge. If level is below "LOW" level
mark, fill hydraulic tank (WP 0018
37
After
Fuel Tank
Refuel roller (WP 0015 00).
38
After
Water Spray
Drain and flush front and rear water
System
tanks. Service all strainers (WP 0024
39
Weekly
Water Spray
a. Remove water spray screen element
System
b. Clean bowl and element with water.
c. Install water spray screen element
d. Repeat steps a through c for second
water tank located on the opposite
end of the roller.
40
Weekly
decay, damage, and loose com-
ponenets.
Pipes
0012 00-17
