Storage
DETROIT DIESEL
e. Refill the converter with the oil that is recommended under Lubrication and Preventive Maintenance.
13. POWER TAKE-OFF
Remove the inspection hole cover and inspect the clutch release lever and link pins and the bearing ends of the clutch
release shaft. Apply engine oil sparingly, if necessary, to these areas.
14. HYDROSTARTER
a. Open the relief valve on the side of the hand pump and release the pressure in the system.
b. Refer to the filling and purging procedures outlined in
Hydraulic Starting System. Then, drain, refill and purge
the Hydrostarter system.
15. TURBOCHARGER
Remove the covers from the turbocharger air inlet and turbine outlet connections. Refer to the lubricating procedure
outlined in Preparation for Starting Engine First Time.
16. After all of the preparations have been completed, start the engine. The small amount of rust preventive compound
which remains in the fuel system will cause a smoky exhaust for a few minutes.
NOTE: Before subjecting the engine to a load or high speed, it is advisable
to check the engine tune-up.
Page 122