NOTES - CONTINUED:
3
ENGINE OIL LEVEL HOT OR COLD CHECK . Cold-engine, oil level should be at high mark on dipstick. Hot
engine, oil level must be between high and low marks on dipstick (allow to set 5 minutes before checking).
4
ENGINE. Oil is to be changed each 100 hours. Drain when lubricant is warm.
5
ENGINE OIL FILTER. Each 100 hours, remove filter element, clean housing and install new filter element.
After installing new filter element, fill crankcase, operate engine for 5 minutes, check housing for leaks, check crankcase
oil level and bring to "FULL" mark.
6
AIR CLEANER . Each 10 hours, refill reservoir to level mark. Each 50 hours disassemble entire unit, clean, re-
oil and assemble.
7
TORQUE CONVERTER FILL. Check level each 50 hours using dipstick and engine stopped. Bring oil level to
"FULL" mark on dipstick.
8
TRANSMISSION. Check level each 250 hours. Change gear lubricant only when required by maintenance
repair action, contamination by water, or other foreign material After refill, operate for five minutes, check for leaks and
bring oil to "FULL" mark.
9
LUBRICANTS. The following is a list of lubricants with military symbols and applicable specification numbers.
OE/HDO
MIL-L-2104
GO
MIL-L-2105
GAA
M I L-G-10924
OEA
M I L-L-46167
(SD), Type II P-D-680
Copy of this Lubrication Order will remain with the equipment at all times, instructions contained herein are mandatory.
By order of the Secretary of the Army:
JOHN A WICKHAM, JR
General, United States Army
Chief of Staff
OFFICIAL:
ROBERT M JOYCE
Major General, United States Army
The Adjutant General
DISTRIBUTION:
To be distributed in accordance with DA Form 12-25B, Operator and Organizational maintenance requirements for
Motorized Rollers.
TA 220577
LO 5- 3895- 263 -12
U.S. GOVERNMENT PRINTING OFFICE 1984-420-903/238
CARD 5 OF 5