Attach a lifting strap and Tool (A) to plate (6). Remove
eight bolts (5), and remove plate (6) from the drum
support housing. The weight of the plate is 115 kg (253
If necessary, remove the ten bolts and ten isolation
mounts (7) from plate (6).
Attach Tooling (B) to drum support housing (8).
Remove eight bolts (9), and drum support housing (8).
The weight of the drum support housing is 41 kg (90 lb).
For installation of the drum support housing,
reverse the removal steps.
Apply 6V-4876 Molykote lubricant to shaft splines
before installing the vibratory motor.
After the drum support housing has been
installed, fill the housing with oil to the correct
level. See the Operation & Maintenance Manual
for the correct procedure.