Position wooden blocks under the right side axle
assembly. Position bracket (71) on right side axle
assembly (72), and install the two nuts. Tighten the
nuts to a torque of 170 to 190 N m (125 to 140 lb-ft).
Attach lifting straps and a hoist to left side axle
assembly (9). Remove 11 bolts (10), and remove the
left side axle assembly from the differential housing.
Remove the inner brake housing, brake torque pin and
outer brake housing from the left side axle assembly.
Follow Steps 2 thru 18 to assemble the left side axle
Position thrust block (12) on the left side axle assembly,
and install two bolts (11). Tighten the bolts to a torque
of 57 to 76 N m (42 to 56 lb-ft).
Use two persons to remove the differential assembly
from the sun gear of the right side axle assembly.
Heat bearing (70) to a temperature of 135C (275F)
and install it on pinion (62).
Heat bearing (69) to a temperature of 135C (275F)
and install it on pinion (62). Install retaining ring (68).
Lower the temperature of bearing cup (66), and install it
in housing (63). Install O-ring seal (67) on the housing.