TM 5-3895-383-24
16.
Install the brake control rod through the seal in the
housing, and position brake actuator assembly (17) on
the disc.
17.
Install a disc, a plate and disc (16) on the brake actuator
assembly.
18.
Make sure the brake discs, plates and brake actuator
assembly are centered. Apply 4C-9507 Retaining
Compound on the threads of the six bolts. Put inner
brake housing (13) in position, and install two nuts (14)
and the six bolts. Tighten the two nuts to a torque of
105 to 143 N m (77 to 105 lb-ft). Tighten the six bolts to
a torque of 150 to 190 N m (110 to 140 lb-ft).
19.
Use lifting straps and a hoist to position right side axle
assembly (72) on the differential housing. Install 11
bolts (73).
20.
Heat bearings (49) and (50) to a temperature of 135C
(275F). Install the bearings on the differential
assembly in their original locations.
21.
Use two persons to install differential assembly (48) on
the sun gear of the right side axle assembly.
22.
Use Tooling (A) to support the left side axle assembly.
Install outer brake housing (27) and brake torque pin
(28) in the left side axle housing.
14-79