Block Mounting Face Shown
Before assembling front housing to cylinder block, clean joint-
face (1) and (2) with 8T9011 Solvent and apply 6V1541 Quick
Cure Primer. Allow primer to air dry (three to five min). Apply
1U8846 Sealant to housing joint-face and spread uniformly.
Housing must be assembled and tightened to the block within
ten minutes. Do not allow gasket maker to plug oil passage
Front Housing Cover
Front Housing Cover. On gasket to cover joint face
(one side only) clean cover face of gasket with solvent.
Apply 1U8846 Gasket Maker to gasket and spread
uniformly and around bolt holes. The cover must be
assembled and tightened within ten minutes.