TM 5-3895-383-10
E-9
E-8. EXHAUST STACK REPLACEMENT
a. Removal.
Do not touch hot exhaust system with bare hands; injury to personnel will result.
(1)
Allow exhaust system to fully cool.
(2)
Open hood (1) (Chapter 4).
(3)
Remove four bolts (2), exhaust stack (3), plate (4), and gasket (5) from hood (1).
b. Installation.
NOTE
Exhaust stack must be installed with opening facing rear of Roller.
(1)
Insert plate (4) through hole in hood (1) and align bolt holes. Hold in place.
(2)
Position gasket (5).
(3)
Have assistant hold exhaust stack (3) and align one set of mating holes in exhaust stack (3) and
hood (1).
(4)
Install one bolt (2) through exhaust stack (3), gasket (5), hood (1), and plate (4). Snug, but do not
tighten bolt.
(5)
Install three bolts (2) through exhaust stack (3), gasket (5), hood (1), and plate (4). Tighten all four
bolts.
(6)
Close hood (1) (Chapter 4).
END OF TASK.