TM 5-3895-382-24
Every 500 Service Hours or 6 Months
You must read and understand the warnings and
instructions contained the Safety Section of this manual
before
performing
any
operation
or
maintenance
procedures.
Before proceeding with this maintenance, perform all
previous maintenance interval requirements.
Blade Cutting Edges
Inspect
Typical Example
Inspect blade cutting edges for loose or missing bolts.
Replace missing bolts and tighten bolts to the specified
torque. See "Torques for Ground Engaging Tools" chart.
Inspect blade cutting edges for damage or excessive
wear. Replace if necessary.
Cooling System
Check/Add Coolant/Add Supplemental
Coolant Additive (As Required)
Maintenance Section
1-82
Every 500 Service Hours or 6 Months