TM 5-3895-382-24
11.
Install washer (32), spring (31) and washer (30) in
cylinder block (25). Put the cylinder block in a press.
Install a suitable piece of square steel stock against
washer (30). Using the press, compress spring (31),
and install retaining ring (29). Slowly release the spring
compression.
NOTE: Position pin retainer (27) at the top of the cylinder
block splines.
12.
Install three pins (28) and pin retainer (27) in the
cylinder block.
13.
Install retainer guide (26) on the cylinder block.
14.
Install seven pistons (23) in slipper guide (24). Install
the slipper guide and the pistons in cylinder block (25).
15.
Use Tool (D) to install cylinder block assembly (21) in
housing (22).
16.
Install pin (20) in swashplate (19). Install sleeve bearing
(18) on pin (20). The notched side of the sleeve bearing
must be facing the convex portion of the swashplate.
16-95