TM 5-3895-382-24
NOTE: There is a snap ring on each side of bearing (8).
6.
Use Tool (C) to remove upper and lower snap rings (7)
from shaft (6). Using a press, remove shaft (6) from
bearing (8).
7.
Put identification marks on two journal bearings (10) as
to their location in the front cover. Remove the two
journal bearings from the front cover. Remove two
spring pins (9) from the front cover.
8.
Remove five bolts (12) and cover (14) from the housing.
Remove the gasket from under the cover.
9.
Remove five bolts (11) and cover (13) from the housing.
Remove gasket (17) from under the cover.
10.
Remove spring (15) and stop (16) from the servo piston.
16-90