TM 5-3895-382-24
8.
Remove notched washer (15), spring (17) and washer
(18).
9.
Remove swash plate (19).
10.
Remove retaining ring (21), seal (22), retaining ring (23)
and remove shaft (24).
11.
Remove retaining ring (25), bearing (26) and retaining
ring (27). Bearing (26) is press fit on shaft (24).
NOTE: The following steps are for the assembly of the
vibratory motor.
NOTE: All motor components must be cleaned and
inspected before assembly. If any components
are worn beyond recommended limits they must
be replaced. Lubricate all moving parts with clean
oil during assembly. Assemble motor with all new
seals.
12.
Install retaining ring (27), bearing (26) and retaining ring
(25). Install shaft (24). Install retaining ring (23), seal
(22) and retaining ring (21).
13.
Install swash plate (19).
NOTE: The notched washer (15) is located between
spring (17) and retaining ring (16).
14.
Instill washer (18), spring (17) and notched washer (15).
16-54