Use a hoist to raise yoke (1), and position wooden
blocks under both sides of the machine frame as shown.
Remove support stands (4) from each side of the yoke.
Lower the frame of the machine onto the wooden
To prevent the yoke from rotating, position support
stand (4) under the right side of yoke (1).
Attach a hoist to yoke (1) as shown.
Remove two bolts (5), and install two 8C-8290 (M24 X
3.0 X 150 mm) bolts (6). Remove the remaining six
bolts (5) and the shims (top and bottom) from behind
plate (7). For assembly purposes, note the quantity and
location of the shims. Move plate (7) away from the
yoke. Attach a hoist to plate (7). Remove two bolts (6),
and remove plate (7). The weight of the plate is 35 kg
Use the hoist to remove yoke (1) from the steer pivot.
The weight of the yoke (with bumper) is 650 kg