Remove four bolts (3) and bearing housing (4).
The bearing housing must be removed in order to
allow clearance for the removal of the flywheel
Remove six bolts (2) and the washers.
Remove flywheel (1) and the ring gear. The weight of
flywheel (1) and the ring gear is 53 kg (120 lbs).
If removal of the ring gear is necessary, place an index
mark on the chamfer of the ring gear for the installation
Use a hammer and a punch in order to remove ring gear
(5) from flywheel (1).
Flywheel - Install
SMCS Code: 1156-012
If ring gear (5) was removed, heat ring gear (5) to a
temperature of 250 C (480 F).
Install ring gear (5) on flywheel (1).
Ensure that the chamfer of the ring gear is in the
correct position on the flywheel.