Cylinder weighs 60 lbs. (27 kg). Care
should be taken when handling
Install cylinder (6) on bumper assembly (7) with
washer (4), bolt (5), washer (4), and nut (3).
Hydraulic oil is slippery and can
cause falls. To avoid injury, wipe up
spilled oil with rags.
assemblies to catch any excess oil
draining from hoses.
Remove caps and install two hoses (1) on
fittings (2). Tighten hoses.
Install two clamp halves (10), hoses (1), clamp
halves (10), and plates (9) on bumper assembly
(7) with two screws (8). Tighten screws to 40 lb-
ft (55 Nm).
Install leveling blade assembly (Para 2-10).
Fill drum gear reducer, drum support housing,
and vibratory bearing reservoir (Para 1-14).
Start engine (TM 5-3895-382-10) and check for
Check for clearance between top of blade
assembly and hoses when blade is in full up
If clearance is needed, loosen screws (8) and adjust hoses (1). Tighten screws.
Adjust smooth drum scraper (subparagraph g).