UNIVERSAL JOINT AND SHAFT MAINTENANCE- CONTINUED
ASSEMBLY - CONTINUED
Wear suitable eye protection during removal of snap rings to protect your eyes in case a snap ring flies
out of universal joint. Failure to follow this warning may cause injury.
Apply a light coat of clean grease inside of bearings prior to assembly.
Install two universals joints (9) on driveshaft with four bearings (8) and snap rings (7).
Install two universal yokes (3) at ends of driveshaft with four bearings (6) and snap rings (5).
Position driveshaft on roller and install eight new lockwashers (2) and bolts (1) on universal yokes (3).
Operate roller and check for proper operation (TM 5-3895-379-10).
END OF WORK PACKAGE
0190 00-3/(0190 00-4 Blank)