TM 5-3895-379-23
PROPEL CONTROL LEVER VIBRATORY SYSTEM ENGAGEMENT
STOPS ADJUSTMENT - CONTINUED
0114 00
ADJUSTMENT - CONTINUED
NOTE
If cams cannot be adjusted to automatically start vibration, engagement switches may need adjustment. If
you have adjusted cams and vibration startup is OK, skip steps 6 through 13.
6.
Remove two screws (4) and washers (5) from operator station (6).
7.
Remove seven screws (4) and washers (7) from operator station (6).
8.
Lift panel assembly (8) and pull away from operator station (6).
9.
Remove four screws (9), washers (10) and propulsion control valve assembly (11) from panel assembly (8).
10.
Loosen two screws (12) and move two engagement switches (13) up until cams (2) engage switches (12). Tighten
screws.
11.
Install propulsion control valve assembly (11) on panel assembly (8) with four washers (10) and screws (9).
12.
Install panel assembly (8) on operator station (6) with two washers (5), seven washers (7) and nine screws (4).
13.
Repeat steps 2 through 5.
14.
Return boot (1) to original position.
15.
Remove chocks (TM 5-3895-379-10).
9
8
4
7
10
6
4
8
7
2
13
11
12
13
5
4
401-614
END OF WORK PACKAGE
0114 00-2