TM 5-3895-379-23-2
0234
INSTALLATION
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during
procedure. Ensure that any lifting device used is in good condition and of suitable load
capacity. Keep clear of heavy parts supported only by lifting device. Failure to follow this
warning may cause injury or death.
NOTE
ROPS assembly weighs 880 lb (399 kg).
1.
Attach lifting device to ROPS assembly (Figure 3, Item 2).
2.
Position ROPS assembly (Figure 3, Item 2) on frame assembly (Figure 3, Item 1).
NOTE
Leave one bolt out of top rear hole on right-side for handrail assembly mounting and one
bolt out of top rear hole and top front hole on left-side for handrail assembly mounting.
Lifting device may be used to shift ROPS assembly for alignment.
Apply oil to threads of bolts before installing. Failure to apply oil can result in improper
3.
Install 11 bolts (Figure 3, Item 3) and washers (Figure 3, Item 4) in ROPS assembly (Figure 3, Item 2) and
frame assembly (Figure 3, Item 1). Tighten bolts to 518-666 lb-ft (702-903 Nm).
4.
Remove lifting device from ROPS assembly (Figure 3, Item 2).
1
2
4
3
1
M1274SWR
Figure 3.
Rollover Protection Structure (ROPS) Assembly Installation.
03/15/2011Rel(1.8)root(maintwp)wpno(M00172)