TM 5-3895-379-23-2
0226
ASSEMBLY
NOTE
Inspect all parts and bore of steering cylinder for cracks and damage. Replace if damage
is found.
During assembly of steering cylinder, apply a thin coat of clean oil on O-ring, back-up
rings, and lip-type seals.
1.
Install new back-up ring (Figure 2, Item 13), new O-ring (Figure 2, Item 14), and new lip-type seal
(Figure 2, Item 9) on inside of head (Figure 2, Item 5).
2.
Install new back-up ring (Figure 2, Item 7) and new O-ring (Figure 2, Item 6) on outside of head
(Figure 2, Item 5).
3.
Install new O-ring (Figure 2, Item 3) and new wear ring (Figure 2, Item 4) on piston (Figure 2, Item 2).
4.
Install new O-ring (Figure 2, Item 16) on rod assembly (Figure 2, Item 10) with nut (Figure 2, Item 1).
5.
Install piston (Figure 2, Item 2) and head (Figure 2, Item 5) on rod assembly (Figure 2, Item 10) with nut
(Figure 2, Item 1). Tighten nut to 590 + 20 lb-ft (800 + 27 Nm).
6.
Slide head (Figure 2, Item 5) and rod assembly (Figure 2, Item 10) in cylinder assembly (Figure 2, Item 17)
and install lockwire ring (Figure 2, Item 8).
7.
Install two new lockwashers (Figure 2, Item 12) and bolts (Figure 2, Item 11) and secure cover
(Figure 2, Item 15) and rod assembly (Figure 2, Item 10) in cylinder (Figure 2, Item 17).
4
6
7
3
9
1
2
5
8
11, 12
10
17
16
15
14
13
M1305SWR
Figure 2. Steering Cylinder Assembly.
END OF TASK
03/15/2011Rel(1.8)root(maintwp)wpno(M00164)