TM 5-3895-379-23-1
0114
FUEL LINES AND FITTINGS INSTALLATION
1.
Install new O-ring (Figure 2, Item 7) and new preformed packing (Figure 2, Item 9) on adapter
(Figure 2, Item 8).
2.
Connect adapter (Figure 2, Item 8) to hose (Figure 2, Item 11) and fuel pump (Figure 2, Item 16).
3.
Install new O-ring (Figure 2, Item 7) and new preformed packing (Figure 2, Item 9).
4.
Connect adapter (Figure 2, Item 8) to hose (Figure 2, Item 11) and primary water separator
(Figure 2, Item 10).
5.
Install new O-ring (Figure 2, Item 7) and new preformed packing (Figure 2, Item 9).
6.
Connect hose (Figure 2, Item 3) to adapter (Figure 2, Item 8) and install hose (Figure 2, Item 3).
7.
Install loop clamp (Figure 2, Item 14) to hose (Figure 2, Item 17).
8.
Install connector (Figure 2, Item 18) and tube (Figure 2, Item 19) to secondary water separator
(Figure 2, Item 20).
9.
Connect hose (Figure 2, Item 17) from connector (Figure 2, Item 18) and install new O-ring (Figure 2, Item 7).
10.
Install two elbows (Figure 2, Item 21) and two valves (Figure 2, Item 1) to fuel tank (Figure 2, Item 2).
11.
Connect hose (Figure 2, Item 9) and hose (Figure 2, Item 17) to two elbows (Figure 2, Item 21) and install new
O-rings (Figure 2, Item 7).
12.
Install bolt (Figure 2, Item 15), two washers (Figure 2, Item 13), and nut (Figure 2, Item 12) to loop clamp
(Figure 2, Item 14).
13.
Install three bolts (Figure 2, Item 5), three plates (Figure 2, Item 6), and six block clamps (Figure 2, Item 4).
14.
Turn two fuel shut-off valves (Figure 2, Item 1) to ON position (WP 0116).
0114-4
03/15/2011Rel(1.8)root(maintwp)wpno(M00052)