TM 5-3895-379-10
OPERATOR PREVENTIVE MAINTENANCE CHECKS AND
SERVICES (PMCS) INTRODUCTION - CONTINUED
0011 00
GENERAL PMCS PROCEDURES - CONTINUED
NOTE
Notify supervisor of any leaks you cannot fix.
Leakage Definitions for PMCS
Class I
Leakage indicated by wetness or discoloration, but not great enough to form
drops.
Class II
Leakage great enough to form drops, but not enough to cause drops to drip from
the item being checked/inspected.
Class III
Leakage great enough to form drops that fall from the item being checked/
inspected.
GENERAL LUBRICATION PROCEDURES
NOTE
Lubrication instructions contained in this PMCS are MANDATORY.
Overall view of lubrication points is located in the Lubrication Chart at the end of this work package. Localized
views are located following the Lubrication Chart. Specific lubrication instructions are contained in the PMCS
The roller is enrolled in the Army Oil Analysis Program (AOAP) for sampling of engine and hydraulic system
oil.
Refer to FM 9-207 for lubrication in arctic operation.
1.
Included in this PMCS are lubrication services to be performed by the operator.
2.
Lubrication intervals are based on normal operation. Lubricate more during constant use and less during inactive periods.
Use correct grade of lubricant for seasonal temperature expected. Refer to the KEY at the end of this work package.
3.
For roller under manufacturer's warranty, hardtime intervals shall be followed. Shorten intervals if lubricants are known
to be contaminated or if operation is under adverse conditions (e.g., longer than usual operating hours, extended idling
periods, extreme dust, etc.).
4.
Keep all lubricants in a closed container and store in a clean, dry place away from extreme heat. Keep container covers
clean and do not allow dust, dirt or other foreign material to mix with lubricants. Keep lubrication equipment clean and
ready for use.
WARNING
Cleaning compound, solvent MIL-PRF-680 Type III is an environmentally compliant and low toxic mate-
rial. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in well-ven-
tilated areas. Keep away from open flames and other sources of ignition.
5.
Clean area around lubrication points with cleaning compound, solvent (Item 3, WP 0029 00) or equivalent before lubricat-
ing equipment. Keep all external parts of equipment not requiring lubrication free of lubricants. After lubrication, wipe off
excess lubricant to prevent accumulation of foreign matter.
6.
Maintain a record of lubrication performed and report any problems noted during lubrication. Refer to DA Pam 738-750
for forms and procedures to record and report any findings.
0011 00-3