TM 5-3895-346-14
STEERING CONTROL RRASSEIMBLY
POWER STEERING
Push the splined end of the drive through the gear so that the spline extends about one-half its length beyond
the meter-gear star and hold it in this position while installing into the unit. Note the position or direction of the
cross pin within the unit. Enter the meter-gear star into the meter-gear ring and wiggle the parts slowly in
position so that the drive does not become disengaged from the meter-gear star. Hold the plate and meter-
gear ring in position on the assembly while the star is being installed. Rotate the meter-gear star slightly to
bring the cross slot of the drive into engagement with the cross pin and the splined end of the drive will drop
down against the plate (refer to Fig. 49, 50, and 51).
Figure 47.
Figure 48.
Figure 49.
Figure
50
Figure 51.
590