g. Installation.
(1)
Lift up the compression roll housing (23) and position it in its proper mounting place.
See that the
mounting holes in the housing and road roller frame are properly alined.
(2)
Install and tighten the compression roll housing mounting screws (7), lockwashers (6), and plain washers (5).
(3)
Install the lifting hooks (21) on the housing (23) and see that the mounting holes in the hooks, housing,
and roller frame are properly alined.
(4)
Install and tighten the long screws (17), lockwashers (16), and plain washers (15).
(5)
Install and tighten the short screws (18), lockwashers (19), and plain washers (20).
(6)
Install the sprinkler tank caps (1).
(7)
Connect the fuel line with the fuel tank.
(8)
Connect the sprinkler hose with the sprinkler tank.
(9)
Connect all linkages and wiring on the bottom part of the housing. Remove the tags from the linkages and
wiring.
159. Operator's Seat Assembly
a. General. The operator's seat can be mounted on the seat posts on the left and right sides of the roller. The
seat posts are welded to the top cover of the roller. The seat is secured to the seat posts with a post pin and cotter pin.
b. Removal.
(1)
Remove and discard the cotter pin securing the seat post pin.
(2)
Remove the seat post pin.
(3)
Lift up and remove the seat.
c.
(1)
Remove the nut (3) and lockwasher (4) attaching the right hand brace (8) to the back rest cushion (1).
(2)
Remove the nut (3) and lockwasher (4) attaching the right-hand brace (8) to the seat cushion (9).
(3)
Remove the right-hand brace (8).
(4)
Remove the left-hand brace (11) in the same manner as the right-hand brace (8).
(5)
Remove the plow bolts (6), lockwashers (4), and nuts (3) attaching the backrest bracket (5) to the
backrest brace (7).
(6)
Remove the backrest bracket (5) and backrest cushion (1).
(7)
Remove the square nuts (3) and lockwashers (4) attaching the seat base (10) to the seat cushion (9).
(8)
Remove the seat base (10) and seat cushion (9).
d. Cleaning. Wash all metal parts in cleaning solvent and wipe them off with a soft absorbent cloth. Clean the
threads of the mounting studs with a stiff wire brush.
182